Skip to main content

VTOL Ornithopter

Now this is a bit of a terminology cluster... VTOL stands for Vertical Take Off and Landing; and an Ornithopter is any flapping winged thing that flies (aka, birds & insects).

This hot number was pieced together from an Air Hogs Avenger back in October of '08. The Air Hogs Avenger was a nice little 4-winged ornithopter with a little too much thrust-to-weight to remain unmodified. I gutted the system and used the wings, gearbox, and motor to make my own, cooler, ornithopter.


I made the airframe out of carbon rod and added elevator control. I also had to replace the radio system to support throttle/rudder/elevator control. Total weight, with battery, is 10.5g and the flight times are over 10 minutes.

This vehicle has the ability to take off and land on its tail, almost hover in place, cruise in level flight, and do loops. It is very responsive and aerodynamically quirky (not in a bad way). Flight stability is great, it can be flown with only rudder control by a novice or flown mildly acrobatically by someone with a bit more skill. Its a really great, weird, vehicle that I have been flying since I built it. I really enjoy cruising this around.

The elevator and rudder control were originally done with magnetic rotary actuators but I have since replaced them each with 400mg linear servos of my own design.



Comments

Other People Thought These Were Cool..

Micro Servos

When I started to take a break from microscopic flying vehicles in 2010 and migrate towards some larger, easier to work with, models (5-20g) I realized that magnetic actuators just weren't going to cut it for control (rudder, elevator, ailerons). Magnetic actuators are heavy and draw power continuously when deflected away from neutral. I needed servos. Servos would provide lots of pulling force for their weight but at the cost of mechanical complexity. Since servos at the weight I needed didn't exist or were out of my price range I decided to further over complicate the situation and build my own. I started by designing a simple linear servo (lead screw design). The picture above is of my 400mg variant which has a throw of about 0.2", resolution of 0.0015", and can pull about a 25g load. The motor is a brushed 3.2mm diameter coreless design by Shicoh. The gears used are module 0.15 and can be gotten from http://www.kkpmo.com/ . The threaded rod is 0000-160, which

3D Printed Mechanical Pencil

What better way is there to spend multiple consecutive weekends than sitting at your computer, redesigning a mechanism that has existed for decades, all to be able to 3D print something that can be bought at the store for less than $1? ... That's right, anything. However, when your co-worker throws down the gauntlet there is only one thing to do. Take it up.

Nerf Desolator Mods & Upgrades

Ever since I was a kid, I enjoyed playing with Nerf guns blasters. I just liked shooting things around the house, which included my brother. I remember shooting suction cup darts at our CRT TV while watching shows (aiming at the characters / actors). It was way too much fun.